The Elegance LED inset electric fire features LED technology designed to significantly improve the flame picture and running performance. LED technology not only provides a deeper, richer flame picture with enhanced flame movement but is also a fraction of the cost to run when compared to a conventional incandescent bulb. It will last a lot longer too. To keep operation simple there are three switch settings: 1) Flame effect only, 2) Flame + 1.0kW Heat and 3) Flame + 2.0kW Heat. The controls are located high underneath the hood for easy accessibility. A discrete fan heater provides forward directional heat and is of good quality to reduce operating noise. The Elegance LED fits a standard fireplace opening, typically 16″ wide x 22″ high (please refer to specification).
For added convenience two spacer frames are provided (supplied fitted) to allow the Elegance LED to be taken out of the box, placed flush against a flat wall and plugged in for instant heat – no chimney or flue depth required. For installation into a fireplace opening, one or both spacer frames can be removed (depending on the available fireplace depth). This provides the following options: fully inset (0 spacers – requires a 114mm fireplace depth), semi-inset (1 spacer fitted – requires a 54mm fireplace depth) or flush-fit (2 spacers – 0mm fireplace depth).
The Elegance fret is a traditional vertical cast design with a modern twist that imitates a classic solid fuel fire grate. It has a curved profile and is intended to stand in front of the fire and frame. The ashpan is a separate component and provides access to the controls (depending on the model). The Elegance fret is a solid brass & black freestanding front, which is independent from the fire. The one-piece frame is held in position with magnets (supplied) and is black with brass effect outlay.
This product is only suitable for well insulated spaces or occasional use.
|Heat Input (High)||2.0kW|
|Heat Input (Low)||1.0kW|
|Heat Output (High)||2.0kW|
|Heat Output (Low)||1.0kW|
|Heat Type||Fan Heater|
|Chimney Flue Compatibility||No Chimney or Flue Required|
|Control Location||High Level - Front - Below Canopy (Manual - Buttons)|
|Manufacturer Guarantee||3 Years|
|Safety Features||Thermal Trip Switch|
|Installation Requirement||Qualified Electrician Recommended|
|Installation Information||All electric fires feature an automatic safety cut-out device. Simply plug into a standard socket. No chimney or flue required. Designed for use in Great Britain and Republic of Ireland only. All fires must be installed in accordance with the manufacturer’s installation and user instructions and current Building Regulations.|
|Technology||Low energy LED flame effect|
|Power Voltage Supply||220 - 240V|
|Control Type||Manual - Buttons & Remote Control|
|Installation Type||Inset or Freestanding|
|Engine Type||LED Electric|
|Width Outline A||480mm|
|Height Outline B||595mm|
|Depth Outline C||114mm|
|Depth Spacer 1 C1||57mm|
|Depth Spacer 2 C2||57mm|
|Firebox Width Min D1||390mm|
|Firebox Width Max D2||480mm|
|Firebox Height E||555mm|
|Fireplace Opening Width Min||400mm|
|Fireplace Opening Width Max||450mm|
|Fireplace Opening Height Min||560mm|
|Fireplace Opening Height Max||580mm|
|Fireplace Opening Depth||0mm (2 spacers), 57mm (1 spacer), 114mm (0 spacers)|